ZerostartZerostart 3600008 Replacement Cordset for Heavy Duty Immersion Heaters and Engine Block Heaters, 6-feet | 120 Volts

Worked great in my 2003 6.0

Works great on my 2014 Ram 3500 4x4 cummins. Went to YouTube to see how to install and installed it in 45 mins. After completing the install, I plugged the cord in and now this keeps my engine block & oil at 100 degrees during these cold South Dakota nights. I like the extra length of the cord. Less money than OEM.

I've used this axact cord on a 2012, 2017 and 2018 ram diesel. The cord is long enough reach the front bumper and give you almost a foot of slack. I used those zip ties that have the Christmas trees on it to secure the wire to the frame. Leave enough slack between the engine and fram because the motor does move. Especially when towing. I just let the plug end lay in front of the intercooler in the front bumper.On the later model 6.7 you will most likely need to remove the air intake hose to access the block heater. On the earlier 6.7 you can access the block heater from the wheel well if you jack the truck up by the frame. Please use a jack stand if you go in through the wheel well.

Put this on my '18 Nissan Titan with the Cummins Diesel (mine came with a block heater) works great.

These are as easy to install as they can be. Much cheaper than the factory cord despite being the same brand. The only thing the factory cord has is better heat shielding and clips to hold it to the frame. I just wish they included the plug rubber cover. I had to buy a separate one for $7 on Amazon. So a little diy mounting, an additional cord cover and you have saved a little money over the factory cord.

Used to replaced a corroded and melted factory heater cable. It’s not as nice as the OEM but it works and was easy to install. Good value for what you get.

The true review would be years down the road, however this fit perfect on my 2000 superduty, seems durable, installed 3 months ago and works perfect so far.

Measures slightly shorter then the OEM Motorcraft part. Motorcraft part includes all new wire shields and Loom. zerostart has no wiring protector so I used the old Loom off the OEM. I OHM Benched tested the wire before I installed to check continuity. My block heater is working again on my 2006 6.0 Diesel.

Good product, worked well and fit well on 90s 4 runner.

Shipping was fast, works as it should!

high quality product and perfect fit on 2007 chevy cobalt

Fits my 2010 Mercedes Benz ml350 blutec. Works as intended. Shipping took longer than expected.

I did a no-no forgot to unplug engine heater on my Dodge truck before leaving the carport. When next I tried plugging it in lots of sparks, clearly the connection to the plug was damaged. Found this replacement for plug and cord on Amazon. It is now installed on the truck, the cord on this one is actually longer and is easier to plug in.Was shipped to me very quickly and arrived in good condition. Thanks!