DEF Fuel Pump Kit Replaces 24 559 02-S 24-559-03-S 24 559 05-S 24-559-08-S 24-559-10-S for Kohler CH18 CH19 CH20 CH22 CH23 CH25 CH640 CH730

We ordered the kit to replace the pump on an old Lincoln Electric Ranger 10,000-Gas Powered AC/DC CC/CV welder.(Stick,Tig,mig) Has 10,000watt generator 4:110 outlets. 1:240 outlet. Kohler engine CH233. Quick and easy to install. Fires right up and Works great! Price was reasonable and shipping was pretty fast-highly recommend this item if you are shopping for a replacement pump/kit.

Had to replace the fuel pump on my Cushman Truckster. The cover bolted right on. Must use the new bolts as there is a design change in the cover. Only problem I had was that the snap ring that was included was not correct for installing the fittings. I could NOT get it expanded enough to press on the lock clips. I ended up using an IC chip puller that had just enough tab to push on the locks. Yes I know what I am doing. I have been a mechanic for over 50 years and have replaced these pumps before. Unfortunately I couldn't find the snap ring from the last pump install. Fuel pump works as it should and it starts immediately and runs fine.

I hardly ever give ratings below 5 but in this case I felt it necessary. The fuel pump arrived on time and in good shape. The 2 issues I had was 1) No instructions at all and 2) The snap ring was too large and would not have worked anyway. Found out from my local mower shop about how you clamp the side of the in and out for the gas fitting, push the fitting in and then take off the snap ring clamp which he did for me as I observed. Everything was fine then. If you order one, be sure you get instructions or ask someone how to attach the fittings and make sure you get the correct size snap ring to complete the job.

Swapped out with this fuel pump today. Easy if you have a little knowledge in mechanics. No instructions come with it. Runs like a champ. 25 dollar fix compared to a 2 or 3 hundred at a shop. Identical to original Cub part at a fraction of the cost.

This is an exact replacement on my Cub V-twin Kohler. Works as it should, and easy enough to change. Couple quick installation tips. Read the simple directions first. A seeming worthless snap-ring comes with it. This is to remove the old fuel fitting "Clips". This is also located higher than the fuel tank, so it may take some time to Prime. After doing my first one, I get the fuel lines positioned where they need to be, then hold the whole thing lower than the tank. This pre-primes the pump, gets all the air out, and it will start much faster!

This works well and fixed my no fuel problem!

Cheap junk. Bolts are junk. Fittings are junk. It works but not till I replaced the mounting bolts with higher quality and the fittings were leaking so I had to replace them. While mounting it I broke a bolt with very little pressure. The diaphragm works which is a good thing, doubt it'll last long though.

Perfect fit. Resolved the issue. Great value.