OEMTOOLS24538 Heavy Duty U Joint Removal Tool, U Joint Press and Removal Tool for Class 7 and 8 Trucks, Universal Joint Press and Extractor

Worked well with Milwaukee impact driver to remove rear driveshaft effortlessly from M1078 Stewart and Stevenson ex-military truck.Super easy to use. Fit perfectly. Pre-lubricated so screw doesn’t bind or spall.

I hope to not use this tool. However, I do own a 2500 Ram with +100k on the odo. The vehicle has 10 u-joints with 40 bearings. Time will tell if this tool is worth the investment.11/6/22 It didn't take long for the first u-joint to go bad. It was one of the worst, RH front knuckle. The tool would not move the u-joint without the addition of heat. The tool did work well to center the new u-joint after clip installation. It's a good tool, but you still have to use your mechanics cap.

NICE

Heavy duty material.

Broke on first use (second cap actually) . Junk casting. Decent design. Job was A dana 44 front axle u-joint on an 08 jeep rubicon. Not a very stuck one either. Had no problem with my old c clamp type tool.OEM Wants customer to pay shipping. Warranty card stated 1 year warranty (ive had it a couple months) while box says limited lifetime. No better than the tool worked and no better than its built i may just cut my losses. Perhaps mine was just defective but having used the tool I can't see how it could last. OEM usually makes decent stuffThis was trash. I'm just out 100 bucks

Whoever invented this, I’d like to buy you a beer. Used this on my Kenworth w 46 Eaton’s. Works perfect. Total game changer.

The media could not be loaded. I am beyond happy. I was knocking the u-joints out with the C clamp style press, using a torch and hammering away to get original u-joints out of 04 Chevy 2500. It took me near half the day for one drive shaft.With the power of this tool. It took me 10 minutes to get both u joints out of the yoke and drive shaft. I was so happy I nearly knocked over the wife rushing inside to tell her. (She doesn’t care btw) but still have to show off my victory!

Tough tool for the price. I was impressed with how well it held up as I used it for something it was not intended for lol. As a heavy diesel mechanic I've ruined many different brands of these and I believe this one will last me awhile. I was able to put a 2.5 foot bar and socket on it and cranked down till it it held my 170 lbs of the ground while bouncing, never stretched the threads. I do use lubricant on the threads as well.Had to use it several times for this job and no issues.DO NOT USE A IMPACT GUN OF ANY KIND WITH THESE.