MHG-043

Really nice of my Gladiator perfect for those times you want to grab a sandwich in the cab great company to work with if you have an issue they're immediately there to help you!!

Not sure how I lived without this overhead light… No more fumbling for the button to turn on the factory overhead lighting… Not to mention, with the factory installed lighting, the passenger has to depend on you if to turn it on. If you are still pondering, watch the video included with this listing. The guy shows you how easy it is , start to finish. NOTE: I had also just ordered silver trim pieces for the Factory overhead light and it just so happened to include the silver trim that you see in this photo, adding to the decoration of this already nice looking, light. All in all, it just makes things look more well, equipped, whether the light is on or not.

Poor adhesive makes it hard to stick up and forget about it. The light should be brighter, but it gets the job done.

Really high quality part much easier to install than I expected. Light fades to full on in about 2 sec same turning off fades from bright to full off in about 2 sec. A really nicely designed accessory.

I read many reviews on this and the reviews are polarizing. IMO, the light is adequate. Nothing impressive about the amount of light it produces, but it does the job fine and you can read stuff with it. I would not be soldering leads on a PCB with this light setup. It sure fills the gap where the factory has left off. The overall build quality of the unit makes all the browny points. It looks OEM and blends well with the rest of interior. The 3M adhesive installation is both convevient but also a curse. You need to have a very clean surface to adhere the light to otherwise you may end up redoing the install with new 3M trim tape. For some reason, the center portion of the light assembly would not completely adhere that it will stay adhered but after a min or so, but I can hear the adhesive give away. Ends of the light assembly also have 3M tape applied to it so overall the light assembly is holding on fine. So the note you should be taking is, work from the center and move out to the side when applying the unit onto its final position. I would be concerned if I was in the South. Light turns on/off slowly/gradually. I wish the timing was a little quicker but still livable. I used the same camera setup to show light on and off. These photos are taken with no street lights around. You can see how much light it is producing. At 99 dollars, it is not cheap but with the quality and the solution that it provides, it is a worthwhile investment for me. I paid for this product.

Very concerned that these are going to fall off. The tape wasn't sticky at all. I notice now all the 5 star reviews are from free product reviews. Also not very bright. Will give it a few days but so far not impressed. I have a lot of other products (cup holders, cord covers on back window, lock covers) and this is the first one I'm not impressed with during install. Update: returned, it fell off day 1

This is by far the best forward dome/ reading light for the Jeep Wrangler. Fit, finish perfect and installation is very easy! My only complaint, Jeep didn’t think of this.

I like the look of it and the functionality of it “but” the adhesive is trash because after cleaning the surface very well and attaching it above the temperature that’s required for it , it has fell down 4 times now! Q; why did they enclose a catch strap? Well this is why . I went and purchased double sided tape , good stuff and reapplied it and been good so far. The tape adhesive isn’t thick enough because the plastic edge keeps it from proper adhesion.!! Before pushing products out , first try them out and get honest reviews! Dirt road creed did this install and review and he lost credibility with me for not being honest with everyone!

If you are looking for a super bright headlight you are out of luck. Very expensive for what it actually does. Very minimal light. Ok product. Nothing crazy.

اضاءتها جميلة